Mama and Child Floral Decoration

Open the design file. You can adjust the size if needed. It is recommended to keep the original settings to avoid reworking later.

Paint the MDF board in your preferred color and allow it to dry completely.

Place the MDF board into the laser cutter.

Measure the distance using the automatic sensor and run the frame preview to check the cutting area.

Start the process. The design will be engraved and cut. This includes the engraved image (e.g. a mother with a child) and all frame parts.

Afterward, remove all parts and clean the edges.

Take the engraved square piece and glue it onto the empty square base.

Make sure it is aligned precisely and flush with the edges.

Use the cut-out “Mum” piece as a stencil.

Place and glue the individual letters into position.

Glue the two equal-length pieces onto the base so that a centered slot is formed.