Mole Patrol The Clockwork Carrot Caper EasterTabletop Board Game

Glue two CamBed parts to a single cambed bushing, again using a playfield support dowel for alignments and be sure the glue flow micro holes are aligned. 

Glue the Bushing Core inside the Mole Control Dial, with one CamBed Bushing on each side. 

Layout box panels exactly as shown then flip the outer panels. Glue together rear panel and then clamp. Allow to set while applying glue to tabs of other panels. I use the unused at this point, front panel, to keep the box square while the glue sets. 

Glue together front inside panel assembly as shown. Clamp, allow to set.

Install Mole Control Dials and CamBed Bushings into inside panel assembly, apply glue, staying away of edges near mechanisms. Install and clamp front panel in place. Allow to set. 

Slide the rear CamBed assembly thru the rear panel and glue a MoleControl Retainer wheel on the the backside to secure. Occasionally give a gentle spin as it sets to make sure it’s free. 

Glue two Mr. Spinny Wheel 1000 to the inside of each Mole Control Dial bushing core. Again give a spin while it sets to be sure it is free. Also you can slide the Mr. Spinny Wheel 3000 assembly thru the CamBed bushing inside the front panel. 

Sand each CamCore shaft until it sets into each assembly so that it isn’t too tight causing friction lengthwise but also not too lose. Now is a good time to try out the CamLock system as well.

Glue a round carrot guide under each hole of the playfield, making sure each is centered for smooth carrot movement. Once set, glue a second half guide on top of each of those as shown. These half guides should always be opposite the cam to avoid obstructing. Once glue has set, sand the edges down a bit and inside each hole to allow smooth movement. 

 Once glue has set, I tape the playfield to the cabinet, then glue the Playfield Supports in place on the underside. 

I put masking tape on playfield top to indicate where the camshaft will set. Now align cam lobes if you choice along the shaft so that they are under each hole. This is where you can make the game your own. 

Once you have a cam setup you wish to try, slide it onto the Modular Cam system,slide the CamLock in place and then slide a CamSpacer. Put the playfield on, pop some carrots into the holes and see how it plays!

 Here is the cam lobe order I cam currently using. 

Layout dice as show, apply glue. Separate slightly then press together. 

Glue weed stems into playfield hole cutouts. Assemble carrots from top to bottom using (2) each of a 1, 2, 3, 4,…. And ONE single 5 on the very bottom. Once glue has fully set, use a belt sander to smooth them out nicely. 

Slide the Mr. Clicky Mole Wheel Indexer into each of the slots on the front panel. Give them a whirl and enjoy the clickety goodness of a build well done! 

Assembly for the Big Hollow victory carrot can be found in my profile. I’m out of pics in this instruction guide!