xTool M1 Test Grids Cutting and Engraving

I decided to make these test grids, because it is so helpful to kinow what setting to use. I hope everyone can enjoy the pleasure of knowing what you want for your settings.

1. To make this first I uploaded a square and created a grid array.
2. Next I set each box in the array to a slightly different setting.
3. I did this for cut, and engrave. 
4. Next I cut the pieces out. 
5. Now you have a perfect test piece. 
6. If you want, you can also engrave your name, or a picture on you test piece.

Use the piece when your not sure what parameters to use. Its very useful!

Enjoy.