Birthday Surprise Flip Gift Box | Rotating ring boxes

Step 1: According to the graphic marked as A in the cutting area on the drawing, there are 6 pieces in total, and assemble according to the scheme shown in the picture. During assembly, note that the inner box is a rectangular cuboid structure with different lengths and needs to be installed and assembled accordingly.

Step two: According to the illustration, wrap the knitted thread around the cow tendon rope, then thread the holes through the two holes in the box. The hole diameter is 3 millimeters, and after the cow cord passes through, it can be easily snapped, making it convenient to install the outer shell later.

Third, use strong glue to stick magnets into the two circular areas on the outside of the box. Pay special attention to ensure the magnet has the same pole orientation to avoid subsequent magnetic attraction with the casing.

Step one: Cut the graphic marked B according to the drawing, with a total of 6 pieces. Following the examples in Pictures 1 and 2, use strong adhesive to secure the small board to the side panel, and install magnets in the circular area.

Step two: Take out the left and right panels with three holes, take out the installed inner box, and thread the ox tendon rope outside the box through the two holes above the side panel. Take out a new ox tendon rope and thread it through the hole below. Then, as shown in Figure 5, loop the lower ox tendon rope around the stick position.

Step 3: According to Figure 7, install the remaining outer box side panels. The base plate and top cover plate will be installed later.

Step one: According to the method in Figure 1, install the outer panel with holes in the corresponding position. As shown in Figure 2, fix the pull tab button with strong adhesive, then insert it into the front hole as shown in Figure 3. Take out the cut small hook and insert it into the corresponding hole, then hang the cow tendon rope at the same time.

Step two: As shown in Images 6 and 7, install the upper flip plate.

The above installation is complete. When rotating the inner box, the cow tendon rope is stretched by rotation, and the pull ring pulls outward to lock onto the already rotated inner box. At this point, the inner box is securely positioned. When pulling the pull ring again, the inner box starts to rotate, and the pull ring immediately retracts. After the inner box rotates, it encounters a magnet and attaches and secures.