Laser Cut Wooden Nativity Christmas Ornament with Happy Birthday Jesus Text

Remix
Instruction
Nativity Happy Birthday Jesus.xcs
Nativity Happy Birthday Jesus
.xcs
Application scenario
Laser processing
Machine & module
xTool M1 Ultra
10W
Compatible xTool Machine
P3
F2
F2 Ultra UV
F2 Ultra(Single)
F2 Ultra
F1 Ultra
F1
F1 Lite
S1
P2S
P2
M1
D1 Pro 2.0
D1 Pro
D1
Laserbox
M2
Accessories
xTool M1 Riser Base with Honeycomb Panel
xTool M1 Air Assist Set
Material used
1/8"(3mm) Basswood Plywood
gift
97
1146

This remix is based on

atomm-remix-cover
Jesus scene Christmas ornament
ironeagle197821

Instruction

1

Step1: What I did for material prep.

Prepped wood by spraying Borax mix (1 tablespoon Borax into 400ml hot tap water) and let it dry completely. Then sprayed a seal coat of gloss clear and let it dry. After the run was done, I used my air compressor to gently blow off each piece and sprayed a final coat of gloss clear. Finished with gently sanding with 400 grit.  

Engrave done at 60% power and 130 speed.  Cut done at 90% and 5.

2

Step2: Resize Text Option: Change horizontal letter spacing to 2 for top and 1 for bottom.

Current text spacing is the default of 0.  Chose which floats your boat :>)

Comments

Remixes