Nativity Countdown Ornament, file formats svg, ai, pdf, dxf,lbrn2 Laser Ready File

Information

      DIGITAL FILE ONLY – NO PHYSICAL PRODUCT WILL BE DELIVERED
This is for the digital cut file of a 3-layer ornament: “Nativity  Countdown Ornament” 
The sample shown measures approximately 4" wide x 5.5" high, but you can resize it as needed.
This file was designed by Burn Graphics and tested on an xTool D1 Pro 20W laser with 3mm basswood plywood using the following LightBurn settings (air assist on):
•	Layer 00 – Line Cut: Speed 309 mm, Power 100%, 1 pass
•	Layer 03 – Line Etch: Speed 3500 mm, Power 60%, 1 pass
•	Layer 01 – Line Etch: Speed 4000 mm, Power 75%, 1 pass
Settings may need adjustment depending on your specific laser and material.