Slate Coaster – “Wine Not?” Wordplay Design

📐 Specifications:

Material: Natural slate stone

Size: 10 × 10 cm (±2 mm)

Thickness: ~5 mm

Shape: Square with natural chipped edges

Design: “Wine Not?” engraved in stylish wine-themed typography

Finish: White/grey permanent engraving

🛠️ Tools & Materials:

xTool S1 (20W)

Slate coaster blank (uncoated)

Masking tape (optional, for clean edges)

Damp cloth for cleaning

🧰 Laser Settings (for slate engraving):

Power: 60–70%

Speed: 100–120 mm/s

Line Density: 254–318 LPI

Air Assist: ON (low)

Tip: Use a font that emphasizes the playful tone — cursive or wine-label style works well.

🧾 Step-by-Step Instructions:

Prepare the coaster

Wipe the slate to remove dust.

Optionally mask the edges.

Create the design

In your software, write “Wine Not?” in an elegant wine-inspired font.

Optionally add a small wine glass or bottle icon.

Size the design to fit centered (~8 cm wide).

Position in the laser

Use a jig or align to the top-left corner.

Autofocus for sharp engraving.

Engrave

Run at recommended settings.

Inspect the contrast; repeat pass if you want bolder engraving.

Clean and finish

Remove masking (if used) and wipe clean.

Optionally seal with a food-safe stone sealant for richer contrast.

💡 Use Cases:

Wine bar tableware

Gifts for wine enthusiasts

Winery souvenir shop products

Housewarming or dinner party presents

Fun addition to a home bar set

🔗 See more handmade laser projects at:
👉 https://sites.google.com/view/gklwooddesign/domovská-stránka