Funny Engraved Wooden Spoon "Stirring Up Trouble"

Instruction

Funny Engraved Wooden Spoon

.xcs

Application scenario

Laser processing

Machine & module

xTool D1 Pro

20W

Compatible xTool Machine

F2 Ultra UV

F2 Ultra（Single）

F2 Ultra

F1 Ultra

F1 Lite

P2S

M1 Ultra

D1 Pro 2.0

Laserbox

Material used

1/4"(6mm) Maple Plywood

921

Information

      For the mom who rules the kitchen—and isn't afraid to cause a little chaos!

Add a dash of humor to her favorite recipes with our "Stirring Up Trouble" Engraved Wooden Spoon. Crafted from durable, solid beechwood, this spoon isn't just a cute piece of kitchen decor; it’s a fully functional, heavy-duty cooking utensil ready for her famous sauces, soups, and batters.

Instruction

Step1

Preparation & Measurements

Measure the Spoon: Use calipers or a ruler to measure the flat wooden area where you want the engraving.
- Example: Let's assume the engravable area is 120mm x 35mm.
Clean the Surface: Wipe the wood with a dry cloth to ensure there is no dust or oil.
Safety First: Put on your laser safety goggles and ensure your ventilation/air purifier is running.

Step2

Design Setup in XCS

Create a Reference Box:
- Open XCS.
- Select the Rectangle Tool and draw a box.
- In the top properties bar, unlock the aspect ratio and type in your exact measurements (e.g., 120mm width, 35mm height).
- Crucial Step: Set this rectangle's processing type to "Output" unchecked (or just use it as a visual guide). This ensures the laser doesn't cut the outline of the box; it's just there to help you center the text.

Step3

Laser Settings (The "Recipe")

These settings depend on your specific xTool machine (D1 Pro, M1, F1, etc.), but here are the standard starting points for Hardwood:

Processing Mode: Engrave
Lines per cm: 100 - 120 (This gives a dark, solid fill).
Power & Speed:
- For 10W Diode (e.g., D1 Pro 10W): 70% Power / 150 mm/s Speed
- For 20W Diode: 40-50% Power / 200 mm/s Speed
- For CO2 (P2): 15-20% Power / 250 mm/s Speed

Step4

Alignment & Framing

Place the Object: Put the spoon on your laser bed (honeycomb or slat). Use blu-tack or tape to hold it perfectly still if needed.
Focus the Laser: Use the kickstand lever (D1/M1) or the auto-measure (F1/P2) to set the correct focal height on the surface of the wood.
Framing (The Most Important Step):
- Click "Framing" in XCS.
- Watch the laser module outline the area.
- Adjust the physical position of the spoon until the framing light sits perfectly centered on the wood.

Step5

Engraving & Clean Up

Start: Click "Process" and then press the start button on your machine.
Watch: Never leave the laser unattended while engraving wood.
Post-Processing:
- After engraving, the wood might have some soot/residue.
- Use a soft brush (like a toothbrush) or a cloth slightly dampened with isopropyl alcohol (rubbing alcohol) to wipe the engraving. This creates that sharp, high-contrast look.

Comments