Reindeer Christmas Tree Ornament

Cut out all of the parts. 

I recommend you try to fit the reindeer in the oval part. if the fit is too tight, lightly sand the opening but not too much.

Add the oval plate to the ring part.

Start by sliding it at an angle to one side. Then press the plate down. Lastly, slide it in the opposite direction until centered.

I recommend you first glue in the tree.

Next, glue in the reindeer. If the fit is too tight then lightly sand the opening. Be careful you don't break it.

Paint the model. 

You could also do this immediately when the model is cut as it may be easier if you also plan to paint the internal surfaces.

Add a piece of string so you can hang your ornament.