Report
![[Laser cut and engrave] Little Laser Craft wooden board with metal connector](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/1e33d989-8228-40cf-b04a-f85006d62da8?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Little Laser Craft wooden board with metal connector](data:image/png;base64,iVBORw0KGgoAAAANSUhEUgAAAAoAAAAKCAYAAACNMs+9AAAAAXNSR0IArs4c6QAAABdJREFUKFNjZCASMBKpjmFUId6QIjp4AAppAAuXjCs4AAAAAElFTkSuQmCC)
![[Laser cut and engrave] Little Laser Craft wooden board with metal connector](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/1e33d989-8228-40cf-b04a-f85006d62da8?x-oss-process=image/resize,w_200,h_150,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Little Laser Craft wooden board with metal connector](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/f540dd72-8a54-4019-aba8-9f9262c471a2.jpeg?x-oss-process=image/resize,w_200,h_150,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Little Laser Craft wooden board with metal connector](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/7f055671-1b6c-4252-80ce-700ed4b37ac4.jpeg?x-oss-process=image/resize,w_200,h_150,limit_0/interlace,1/format,webp/auto-orient,1)
Self centered alignment tool
Instruction
Selfcenteredalignmenttool22.01.2025V1
.xcs
Application scenario
Laser processing (10min)
Machine & module
xTool S1
40WMaterial used
1/8"(3mm) Basswood Plywood
2x M4 screw and nut
70
1710
Instruction
1
Step1: Cut it
Preview
Cut the two pieces out
2
Step2: Glue it
Preview
Preview
Glue it together and insert the two M4 nuts
3
Step3: Assamble it
Preview
Preview
Screw the screws into the nuts from the other side. Done
4
Step4: Execution
Preview
Preview
Preview
Preview
Push the tool with the screws flush against your workpiece, as shown in image 1. Then, insert a pencil into the top hole and draw an even line on the workpiece by moving the tool from top to bottom while ensuring that the screws remain in constant contact with the workpiece.
Comments
