Report

[Other] Hand weaving with wooden needle and gray yarn — Project made with S1 machine for Laser cut and engrave.

Loom

Instruction

Weavingloom_2

.xcs

Application scenario

Other (22min)

Machine & module

xTool S1

40W

Compatible xTool Machine

F2 Ultra UV

F2 Ultra（Single）

F2 Ultra

F1 Ultra

F1 Lite

P2S

M1 Ultra

D1 Pro 2.0

D1 Pro

Laserbox

Accessories

xTool S1 40W Laser Module

xTool S1 Honeycomb Panel

xTool 6-inch 410 CFM Inline Duct Fan

Material used

1/8"(3mm) Pine Ponderosa Plywood

acrylic

113

2598

Information

      This file contains a simple hand weaving loom suitable for use in a beginner textile class. Canvas 1 has a small loom and canvas 2 has a large loom. All the tools to get started are included on the tool card. Chop, change and resize the needles as needed to suit your wool or weaving material. The loom is set up for quarter inch spacing/ 4EPI.

Instruction

Step1

Preview

This is a point and shoot project which is very easy to achieve. I needed affordable looms for a textile class I was running and did not wish to drop $15.00-90.00 on “beginner” looms.

Each loom can be produced for under $2.00 using a variety of materials. Load in your materials, adjust settings to suit the best cut and start weaving. Use every pick, every second pick, or every third pick depending on the size of the material and the finish desired.

Engraved on the comb is a common pattern used to create a herring bone weave as shown in the project pictures.

Comments