Lace and leather bracelet -Bracelet de dentelle et de cuir

The engraving and leather cutting operations are carried out in the same phase. Simply place the piece of leather flat, held at all 4 corners with magnets, on the laser machine table.

Once the leather has been cut and engraved, run a dry toothbrush over the engravings to clean them. Then apply a leather oil or grease to the engraved side to clean and soften the leather, so as not to irritate the skin of the wearer's wrist.

In the . XCS design, there are 2 clasp models, one rectangular and one circular.

The decoration is a Greek frieze.

The

work of engraving and cutting the leather is done in the same phase. Simply place the  piece of leather flat, held at the 4 corners with the magnets, on the table of the laser machine.

Once the leather has been cut and engraved, run a toothbrush, dry over the engravings to clean them. Then apply a leather oil or grease to the engraved side to clean and soften the leather so as not to irritate the skin of the wrist of the person who will wear the bracelet.

In the drawing. XCS, there are 2 clasp designs, one rectangular and one circular.

The decoration is a Greek frieze.

This 2-part leather clasp is to be fitted with a snap fastener, crimped in 2 parts (male and female).

Before crimping the snap, sew the lace ribbon to the 2 pieces of leather using thread and 2 saddle-stitch needles, following the holes cut out.

The lace ribbon can be replaced by any other type of ribbon, as lace is not easy to make!

This

2-part leather clasp must be equipped with a press stud, set in 2 parts (male and female).

Before crimping the press stud, you have to sew the lace ribbon on the 2 pieces of leather with thread and 2 saddle stitch needles following the cut holes. 

lace ribbon can be replaced by any other type of ribbon because lace is not easy to make!