HomeLaser&Cut ProjectsHome DecorMirror
Johann Puntigam
Johann Puntigam
Report
[Laser cut and engrave] ´Deep Relief Krampus mirrow
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] ´Deep Relief Krampus mirrow
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] ´Deep Relief Krampus mirrow
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] ´Deep Relief Krampus mirrow
[Laser cut and engrave] ´Deep Relief Krampus mirrow
[Laser cut and engrave] ´Deep Relief Krampus mirrow
[Laser cut and engrave] ´Deep Relief Krampus mirrow
[Laser cut and engrave] ´Deep Relief Krampus mirrow
[Laser cut and engrave] ´Deep Relief Krampus mirrow

´Deep Relief Krampus mirrow

Instruction
KrampusaufSpiegel.xcs
KrampusaufSpiegel
.xcs
Application scenario
Laser processing (140min)
Machine & module
xTool M1
10W
Accessories
xTool M1 Air Assist Set
Material used
Mirrow
Back of mirrow
gift
38
1312

Information

      [Style] Low relief
[Prompt] Krampus whole, on the legs with hooves and on the back a backpack
AImake
AImakeContest

Instruction

1

Step1: Settings Power 60%, Speed 120 mm/s, 200 Lines/cm

I used a mirror with 200x200mm.

Before I started engraving, I drew a square with 202 x 202 mm, which only serves for the correct positioning of the graphic or to move to the frame on a sheet of paper and then placed the mirror upside down on it.

 

Then I adjusted the size of the graphic to 150 x 150 mm and positioned it in the middle of the square. The Square Deleted.

Started the laser engraving process.

 

Nach dem Gravieren noch ordentlich reinigen

 

And if you like, still deposit with a color,

Will try it with LED´s in color, and frame

Comments

Remixes

License

CC BY
This work contains AI-generated content.