Christmas Stocking Earrings

Use of the Honeycomb and Air assist is suggested.  I did not attempt to process without either.

Ensure that the machine measures properly.

Use “Framing” to properly place the design onto the material.

Cut the red and white components.

1.  Lightly sand edges to remove rough edges and burrs.  Do not over-sand mating surfaces as they are cut to fit together.  Avoid sanding the top and bottom surfaces.
2. Wipe down surfaces with microfiber cloth to remove finger prints and clean off surfaces prior to glue.
3. Glue the two hat pieces together
4. after glue has cured, use Novus plastic polish 1 to clean the surface.  Then use Novus 2 if any buffing is needed.  Novus 2 helps remove any marks/smudges from super glue spill.  Follow up again with Novus 1 to clean the surface.
5. Enjoy.