Scott

Report

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb — Project made with xTool S1 machine for Laser cut and engrave.

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb — Project made with xTool S1 machine for Laser cut and engrave.

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb — Project made with xTool S1 machine for Laser cut and engrave.

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb — Project made with xTool S1 machine for Laser cut and engrave.

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb — Project made with xTool S1 machine for Laser cut and engrave.

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb — Project made with xTool S1 machine for Laser cut and engrave.

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb

[Laser cut and engrave] XCS image acquisition sticker holders for honeycomb

XCS image acquisition sticker holders for honeycomb

Instruction

Camerastickerholders.xcs

Camerastickerholders

.xcs

Application scenario

Laser processing

Machine & module

xTool S1

40W

Compatible xTool Machine

New

M2

10W, 20W

F2 Ultra UV

5W

F2

15W

P3

80W

F2 Ultra

40W

F1 Ultra

20W

M1

5W, 10W

D1

5W, 10W, 20W

D1 Pro

5W, 10W, 20W, 40W

P2

55W

F1

10W

S1

10W, 20W

M1 Ultra

10W, 20W

P2S

55W

Material used

1/8"(3mm) Basswood Plywood

gift

26

1316

Information

      Inserts for the S1 honeycomb to hold the image acquisition stickers

Instruction

1

Step1

I would first refer you to the following xtool link and follow the instructions for placement within the machine:

https://support.xtool.com/article/1299

After you have printed your markers from the link above then cut this project from 3mm basswood and glued the pieces together. Next paint with black paint or use a black sharpie on the platform section before gluing the marker pieces to the center. (not painting the platform piece will cause the XCS camera acquisition to fail).

Comments

Remixes

License

You may also like