HomeLaser ProjectsOther
PILED
PILED
Report
[Laser cut and engrave] Rust Removal
Project made with F1 machine for Laser cut and engrave.
Project made with F1 machine for Laser cut and engrave.
[Laser cut and engrave] Rust Removal
[Laser cut and engrave] Rust Removal
[Laser cut and engrave] Rust Removal
[Laser cut and engrave] Rust Removal

Rust Removal

ID 7796
Instruction
Files
Original files
AuthorF1 · Stainless Steel
1
Preview
Preview
Preview
Add Make Profile
Same design, different machine, material, or any improvement · Earn 100 Credits
Tips for a great Make Profile →
gift
119
3363

Information

      I used the 2W IR laser to remove rust from an old chisel
rust
removal
tool
repair
steel

Instruction

1

Step1: Clean

Rust Removal instruction: step 1 - Clean
Preview

First, remove any excess rust. I used a scourer under the sink.

Then, completely dry with a paper towel.

Before above, after below. 

2

Step2: Preparation

Rust Removal instruction: step 2 - Preparation
Preview

Measure the length and width of the tool then change the square size in xTool creative space file.

Check the size is correct by framing. 

 

 

3

Step3: Engrave

Rust Removal instruction: step 3 - Engrave
Preview

90% of the surface-level rust has been removed from just one pass. More scouring of the most rusted spots would have ensured a more even finish. 

Before above, after below. 

Comments

Remixes

License

CC BY-NC-SA