Report
![[Laser cut and engrave] Leatherette Keychain Jig](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/7392158e-fb05-47bf-9069-93e34c0caefa.png?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Leatherette Keychain Jig
InstructionleatherettekeychainJIGv2
.xcs
Application scenario
Laser processing
Machine & module
xTool S1
20WCompatibles · 11
Material used
1/4"(6mm) Walnut Plywood
66
485
Information
Made this jig for large batch processing of leatherette key chains.
Instruction
1
Step1
Preview
Preview
Preview
Place your 12x24 in. panel in the S1, make sure the right side is snug against the wall while being carful not to have it on top of the lip, line up corners shown with the black screws. I lined it up with the side of the screw closest to me when S1 was open.
2
Step2
Go to XCS. Frame to make sure its in your area that you want it. Then process.
3
Step3
Once complete make note where you lined up your corners if you didn't follow the 1st step or had to move the panel for some reason.
4
Step4
Now you can use the jig! Back on the XCS go to your laser settings and change the output to off. Select all items and lock into place. The shapes are color coded and can be used to get a rough estimate of work area on the keychain.
5
Step5
Preview
And finally Enjoy!
Comments
