Glass Baking Dish with Laser Engraved Baked With Love Design

Laser Engraving Instructions

Deep-Dish Pyrex Glass Casserole (Bottom Engrave, Read from Above)

This process was used specifically on a deep-dish Pyrex glass casserole with the design engraved on the underside so it is visible from above during use.

Preparation

Mask the dish
Tape off the sides and handles, leaving only the flat bottom surface exposed for engraving.

Apply paint mask
Spray the exposed bottom with black spray paint, applying a slightly heavier coat than average, but not excessively thick. Allow to dry completely.

Position the dish
Place the casserole dish upside down on the laser bed.

Set height and focus

Raise or lower the tray to accommodate the dish depth.

Move the laser head over the center of the dish and set proper focus.

Frame the job
Mark your work area to ensure proper placement.
Note: Any outer box in the file is used only for centering and alignment and should be set to “Ignore.”

Laser Settings

Machine: xTool S1 – 40W

Power: 70%

Speed: 80

Lines: 180 LPI (LCM)

Cleanup & Finishing

Remove the paint mask using 90% isopropyl alcohol.

Wash the dish in the dishwasher on the sanitize cycle to fully clean and set the engraving.

Final Result

The engraving is permanently etched into the underside of the glass, making it:

Food-safe

Dishwasher-safe

Protected from wear

Clearly visible from above during use

Enjoy your finished piece!