Laser Engraved Ceramic Coaster with Hand in Hand Design

Step 1: cut the laser marking paper in this case 150mmx150mm

Step 2: Clean the tile with some alcohol

Step 3: Soak the lasermarking paper in water for 30 to 60 seconds

Step 4: Gently take the lasermarking paper and take off the painted layer from the paper 

(be carefull)

Step 5: Lay down (nice and easy) the lasermarking paper on the tile 

Step 6: Now gently take all the bubbles out under the lasermarking paper with a squeegee be carefull not to rip the lasermarkingpaper(tip before using the squeegee make it wet it will slide easier over the lasermarking paper)

Step 7: Let the tile dry for 30 minutes(i prepare them and go drink some coffee amount of time)

Step 8: Now its ready to laser youre project onto the tile

Step 9: After finishing take the tile let it soak again for 10 to 15 minutes to peel of the residu off the lasermarking paper and voila you can see the final result.

I hope this was helpfull.