claudio.bellomo77

Report

[Laser cut and engrave] Laser Engraved Wooden Cutting Board with Cartoon Desert Scene — Project made with xTool F2 machine for Laser cut and engrave.

Can you run faster ?!?

Cutting Board Contest

Instruction

Coyote ultimo

.xcs

Application scenario

Laser processing (8min)

Machine & module

xTool F2

5W, 15W

Material used

wood

Information

      
A fun cutting board or breakfast board, but not bad on the wall!! The idea is a motivational scene to get you going after a snack. The scene is dynamic and takes us back to a hot, dusty desert landscape, where someone never gives up because of hunger but CAN HIM RUN FASTER ??

Instruction

Step1

Here's the story:

I imagined the scene in my mind and added it one piece at time, finally the sentence at the bottom, which is the title.Start by getting the material to create your project, then use the file you find here to engrave each element step by step (i did this with my F2). All you have to do is adjust the dimension , the setting are ready.To reproduce the scene you can use my project.Remember to test it on your material and make adjustments if necessary.

Comments