andreasoup

Report

[Laser cut and engrave] Laser Cut Wooden Pegboard with Decorative Pins and Hooks — Project made with xTool S1 machine for Laser cut and engrave.

Hanging Pin Trader, earring or jewelry display

Instruction

pin trader or earring closet hanger

.xcs

Application scenario

Laser processing

Machine & module

xTool S1

40W

Compatibles · 13

Material used

1/8"(3mm) Basswood Plywood

Information

      This is a front and back hanging pin trader display, designed to hold pins or earrings on a closet hanger. The display sides are large and front and back. This pattern is blank, so you can engrave any image on it that you would like! The display's middle is bendable and can be gently pulled apart to slip a hanger through the middle. It's two-sided hanging display, so the backs of your pins are not visible, expanding your display area, and it can easily hang in your closet, freeing up counter and wall space!

Instruction

Step1: import file, configure settings to your preference and cut. Add an engraved image overlay if you'd like.

This is a front and back hanging pin trader display, designed to hold pins or earrings on a closet hanger. The display sides are large and front and back. This pattern is blank, so you can engrave any image on it that you would like! The display's middle is bendable and can be gently pulled apart to slip a hanger through the middle. It's two-sided hanging display, so the backs of your pins are not visible, expanding your display area, and it can easily hang in your closet, freeing up counter and wall space!

Steps: Import file, configure settings to your preference and cut.

Add an engraved image overlay if you'd like.

I don't recommending resizing the pattern, as resizing may affect the stability of the bendy accordian middle section of the display making it fragile.

Comments