Laser Cut Model: Overlanding Rover

Information

      This model, based on the original 3mm cut file, has been modified to use 5mm plywood. It increases the approach and departure angles of the vehicle. Added roof racks, and a revised grill and higher clearance. 
However, there are some small parts that use 3mm plywood. So, to make this model you will need both 3mm and 5mm plywood, but 90% of the parts are 5mm. 

PS. The 1/4" plywood that I got from the local store is actually only 5mm, instead of 6.35mm.  So, if you use 6mm, or true 1/4" plywood, you will have to adjust the finger joint depths, and also widths of some panel, since it will change the width of the vehicle.