![[Laser cut and engrave] Star Box with non-slip lid](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/c0970c6f-d76b-4b1a-8c50-b2b152b5c51a.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Star Box with non-slip lid](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Star Box with non-slip lid
Instruction
Information
Star Box for small Christmas presents. 10 cm x 4 cm with a lid that fits in
Instruction
Step1
First make sure, that you follow the safety instructions of your laser maschine. Then make sure the settings fits to the material you use.
1. Cut out all parts. Caution: The template only works with 3mm thick material.
2. Glue the side panels to the bottom (full star with large edges).
3. Glue the top (star with edges and star cutout) on it. Work carefully.
4. Assemble the lid. First, glue the largest full star with the star cut out from the top of the body.
5. Check if the lid fits well on the body, adjust while the glue is still wet. Important: remove the lid again and let it dry.
6. Lid decoration. First, small star with edges.
7. In the center, place one of the smallest stars. See picture.
8. Then place the remaining two stars from large to small.
