Report

[Laser cut and engrave] Volume Dial — Project made with F1 machine for Laser cut and engrave.

Volume Dial

Instruction

Files

Original files

AuthorF1 · White ABS Plastic

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

2611

Information

      The volume indicator on my Logitech Z533 speaker volume dial was almost impossible to see so I etched an indicator.

Instruction

Step1: Clean Your Dial

Preview

This surface is frequently touched so it should be cleaned first. I used isopropyl alcohol to remove any oils from the surface that might interfere with the etching quality. Soap and water would also work.

Step2: Alignment

Preview

Align your dial with where you want the pointer aligned to the front of the machine.

Step3: Final Step

Preview

Settings used:

IR 2W

Power (%) 100

Speed (mm/s) 2000

Pass 1

Lines per cm 100

Etch and Enjoy!

Comments

Remixes

License

CC BY-NC-SA

Volume Dial

Information