Wall bracket for Father's Day wall sign

A logical first step. Making the parts. 
Although this is a standard process, I have highlighted the making of the cloverleaf for you.

The cloverleaf

1. Now go to settings in XCS and turn only cutting of sheet on "output" on and engraving (and possibly the rest of the "output" on off.
2. You must first cut out the cloverleaf (with the plastic protections on it).
3. Process done? THEN LEAVE EVERYTHING AS IT IS!
4. How do I remove the cloverleaf from the plate without moving it?
   1. Take a piece of paper tape
   2. Make a circle around your finger, with the sticky part on the outside
   3. Now press your finger on the cloverleaf. If everything is cut out correctly, you should now lift the cloverleaf out of the entire plate without it shifting.

If this does not work, the figure is not yet completely loose from the plate and you will have to repeat the cutting process.
(This would not be a problem if you did not shift the plate.)

d. Remove the plastic protection from the cloverleaf and carefully place it back into the plate.

e. Now go to settings in XCS and turn the cutting "output" off and engraving "output" to on (green).

f. Start proces. → Finish.

g. Get off all the protection from the acrylaat 

We use the first complete runner as a base. We glue the other runner on top of that, which has a recess.

Note:

Make sure you work securely. Otherwise you run the risk that subsequent parts will not fit.

Always apply the glue to the part you are going to glue and not the construction itself.

This way, surfaces that still need to be used, or where other things need to be used later, remain (still) free of (dried) glue.

Now mount the last MDF layer.

If you have done everything correctly the construction is as follows:

• 1 full layer mdf
• 1 layer mdf with acrylate,
• 1 layer mdf
   

Look at the photo. Here you can see how the wall plates should be glued together. Start by gluing the 3 MDF plates together and then finally the back (wood plate).

The plate on The front with the top, is not glued yet.

Note:
The wall plates are not identical with front and back. So look carefully that the plates are on top of each other in such a way that you have nice holes.

We are going to assemble the 2 parts.

1. First we are going to glue the plate with the top.
2. We also put glue on the back of the hole.
3. Now we put the legs of the shelves through the first plate with the top and then through the other plates (3xmdf + 1x wood)
4. Put some glue on the half leaves on the front of the shelf. (see photo).
5. Now press everything together and push down as far as possible.
   At the back, the leg of the shelves will fit neatly into the hole.
6. If everting is in place? Now you can position the front plate with the leaf properly, so that it runs parallel to the edges of the other shelves
7. Press everything firmly and remove any glue that comes out from under the parts.

If you want to hang your creation outside, it is important to protect it from moisture and of course use waterproof glue.

Some parts are already covered once. 

You can also treat this once now again

Acrylic and varnish are not friends of each other. Therefore please protect the acrylic with paper tape before  you are going to varnish the entire project again.