HomeLaser ProjectsToolsTest Grid
strunkcustomrods
strunkcustomrods
Report
[Laser cut and engrave] Xtool F1 grid
Project made with F1 machine for Laser cut and engrave.
[Laser cut and engrave] Xtool F1 grid
[Laser cut and engrave] Xtool F1 grid

Xtool F1 grid

ID 4375
Instruction
Files
Original files
AuthorF1 · Stainless Steel
1
Preview
Preview
Add Make Profile
Same design, different machine, material, or any improvement · Earn 100 Credits
Tips for a great Make Profile →
gift
978
12194

Information

      In this How-To you will add a grid to your F1 base plate. The grid is at 10mm intervals and will make alignment from XCS to your machine easier especially when using the mobile app. 
NOTE: THIS WILL PERMANENTLY MARK YOUR F1 BASE PLATE AND CAN NOT BE REMOVED. MAKE SURE YOU REALLY WANT THIS GRID BEFORE YOU RUN THE FILES.
Alignment marks
Grid
F1

Instruction

1

Step1: Clean your base plate

Make sure your base plate is clean and free of any debris. I wiped mine down with a little rubbing alcohol.  

2

Step2: focus your laser

Focus your laser on your base plate, this can be done manually or by using the autofocus.  

3

Step3: Run the project file

Run both canvases, first run canvas 1 IR at 100% at 8mm/sec, and then run the second canvas running blue light at 100% power at 8mm/sec.

NOTE: THIS WILL PERMANENTLY MARK YOUR BASE PLATE AND CAN NOT BE UNDONE. MAKE SURE YOU REALLY WANT A GRID MARKED ONTO YOUR F1. 

Comments

Remixes