Customizable Money/Travel Bank

1. Prepare the Laser Cutter:

• Load the 3mm Maple Plywood into your laser cutter.
• Open the design file in Creative Space Software and ensure the layout fits within the material boundaries.
• Secure the plywood to the laser bed to prevent movement during cutting.
• Swap the tray to the honeycomb tray or add raiser under the 3mm Plywood
• (Optional) Use some tape to hold down the board if needed. 
• Enable the output 

2. Set Cutting Parameters:

• Adjust the laser focus height and define the cutting boundaries according to your material and machine specifications.
• Double-check settings to ensure clean cuts.

3. Run the File:

• Begin the cutting process. 
• Monitor the process to ensure accuracy.

If you want, you can paint the gears with acrylic paint before gluing

I had the best experience when gluing everything together by following these steps:

1. Glue the side parts together, as shown in the picture. 
2. Let it dry well and make sure everything is straight.

This way, the basic frame will already be assembled, and next, you can move to the side front and back. 

Next, take the two pieces (front and back panel) as shown in the picture and attache the panels with the four hinges to the frame. Two for each side

1. Gently press the two wooden pieces into the designated slots with slight pressure. Be careful not to apply too much force.
2. Repeat this process for the other side, make sure both sides are attached in the correct orientation.