foxdaemonkiniata

Report

[Laser cut and engrave] Engraved circular wooden plaque with a wolf design — Project made with xTool F1 Ultra machine for Laser cut and engrave.

Fenrick The Wolf

Instruction

_1_727235

.png

Application scenario

Laser processing (300min)

Machine & module

xTool F1 Ultra

20W

Material used

3mm Brass Coin Blank

894

Information

      Embossed Brass Coin Using The F1 Ultra.  After the the embossing was completed, a 10 pass cleaning run was done to blow away the excess leftover materials.  Unfortunately the rest of my tools are in storage while between houses, so I haven't had the chance to do some finer polishing for the end product.

Instruction

Step1: Embossing The Coin

Use The Applied Setting As Described Above. These were done using a 40mm x 3mm solid brass coin blank. Approximate Run Time Is About 4 - 5 Hours.

Step2: Coin Clean-Up

All this does is help dislodge and push any excess material left behind by the embossment process away. After running this process, it is still recommended to give your project a quick rinse to dry of. Normally I'd use a rotary tool to help make the design shine up a bit, but those are currently in storage.

Comments