Mulilayer LED Frame

Laser everything together
the spacers are in one layer so that you have less wood loss 

The practical thing here is that you can take A4-sized wood and use up almost all of it

Everything ready

1. Deep picture frame 20x25
2. Layers 3mm
3. LED light
4. Spacer
    

1. I made the layers in green
2. the couple in gold
3. the backplate black little dots with white & gold for the stars

1. place the layer in the frame
2. glue a spacer in each corner

• place the 2nd layer on the led strip 
• lay the led strip all around -
  make sure that the beginning is at the bottom left because there is an opening at the 3rd layer
• the strip here has an adhesive strip on the back otherwise with a double-sided adhesive tape

1. insert the spacers again put the 3rd layer on top
2. put another spacer in and then the backplate on top

here is another example of what the frame would look like in black

• measure the inner width of the picture frame
• create a rectangle in this size
• create a 1cm smaller rectangle
• connect both to a compound vector

• Add a tree to the workspace 
  here I took the upper part of a tree as a bush
• Remove the remaining part with a rectangle
• Connect the bush and the tree
• Place the tree in the frame
• Remove the overhang with a rectangle
• Connect the trees to the frame

for the couple i use the AI

i use the prompt 
"Silhouette of Couple Walking Hand in Hand"

load this in XCS in choose trace image

remove all other lines and vectors