Report
![[Laser cut and engrave] Wallart of Feathers](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/a8cebc57-b67c-4d4a-98b3-c9df20fb9006?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Wallart of Feathers](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Wallart of Feathers
InstructionWallArt 3
.svg
Application scenario
Laser (250min)
Machine & module
xTool D1 Pro
10WMaterial used
1/8"(3mm) Birch Plywood
55
663
Instruction
1
Step1
Put the design on the Creative Space with the Laser Extension Kit because the size of the cut
it's of 15x30 inches.
I don't remember to much the settings but i think I used my base settings that I use everytime
90 or 100 power, 2/ms speed and 2 or 3 passes to be sure that it's a clean cut using the Air Assist or it will burn your cut and will became really messy and dirty.
Then I like to paint with Gold Bronze spray because I'm not good with the brush so I use spray
2 or 3 passes and then finish with glossy varnish 2 passes to seal the plywood.
Comments
