Report

Layered Heart Photo Frame Wall Art | 3 Photo Display | Laser Cut File

Instruction
HEARTS WALL PHOTO HOLDER.xcs
HEARTS WALL PHOTO HOLDER
.xcs
Application scenario
Laser processing (13min)
Machine & module
xTool F1
2W, 10W
Compatible xTool Machine
P3
F2
F2 Ultra UV
F2 Ultra(Single)
F2 Ultra
F1 Ultra
F1 Lite
S1
P2S
P2
M1 Ultra
M1
D1 Pro 2.0
D1 Pro
D1
Laserbox
M2
Material used
1/8"(3mm) MDF Board
gift
229
3187

Information

      I created this layered heart photo wall piece to turn standard photos into a premium, decorative feature. The design uses a two-layer build where the bottom layer holds the photos, while the top layer is cut into heart shapes to frame each image cleanly. This creates depth, strong contrast, and a high-end look that works perfectly for family photos, couples, or pet memories as a wall display.
    

Instruction

1

Step1: Step 1

Cut the bottom backing layer from your chosen material (MDF, walnut, etc.) ensuring it is fully solid with no cut-outs.

2

Step2: Step 2

Cut the top layer with the heart-shaped openings, making sure all edges are clean and smooth for a tight finish.

3

Step3: Step 3

Lightly sand both layers to remove any burn marks and improve the final finish.

4

Step4: Step 4

Prepare your photos by resizing them slightly larger than each heart opening so they sit behind the cut-outs with full coverage.

5

Step5: Step 5

Attach the photos to the back layer using adhesive spray or double-sided adhesive sheets, making sure they are flat with no bubbles.

6

Step6: Step 6

Align the top layer over the photos carefully so each image is perfectly framed within the heart shapes.

7

Step7: Step 7

Glue the layers together evenly and apply pressure while drying to avoid gaps between layers.

8

Step8: Step 8

Use a utility knife to cut any photos over lapping the frame.

9

Step9: Step 9

Finish with oil, wax, or lacquer to enhance the wood grain and give a premium look.

10

Step10: Size

Best Overall Size 

Height: 300mm – 350mm
 

Comments

Remixes

You may also like