TANKSLASERS

White Glazed Ceramic Board

White Glazed Ceramic Board
Engrave
1 10mm/s 50%

MachineM2(Blue light · 10W)

Processing ModeProcess on baseplate

Processing typeEngrave

Thickness7.9mm

Material colorWhite

Settings

Pass1

Speed10mm/s

Power50%

Spacing100°

Engraving modeBi-directional

Airflow of air pump15%

Min Output Power3%

Cross hatchfalse°

Power control modeFOLLOW_ACTUALLY_POWER

Outline tracingfalse

Version: 2.0.0

Parameter ConverterLimited-time Free

Convert to My Machine Parameters

Precautions

Wear goggles that match the wavelength of the light source

When operating with open covers or using open-type devices, be sure to wear laser goggles that match the wavelength of the light source. Different light sources (blue light/infrared/CO2/UV) have different wavelengths; please pay attention to whether the wavelength protected by the goggles matches the laser;

Flammable materials should be placed near the smoke exhaust outlet

Flammable materials such as wood, paper, and fabrics should be placed near the exhaust outlet, so that sparks and smoke generated during processing can be promptly removed, reducing the risk of ignition.

Pay attention to odor prevention during processing

Materials such as leather, rubber, and silicone produce noticeable odors; ensure good ventilation and wear protective masks if necessary.

Handling when a flame alarm appears

If a flame alarm is triggered when processing flammable materials such as plywood, acrylic, or polyester mesh: stop processing immediately, maintain smoke exhaust operation, and only open the lid after confirming there is no open flame. Do not open the lid directly to promote ignition.