SANSOOA

natural bamboo wood coaster

Personalized bamboo mug holder engraved with a humorous birthday message for coffee lovers. Created using the xTool M1 Ultra 20W on natural bamboo. The engraving was completed in a single pass, producing a clean, dark contrast while preserving the natural appearance of the wood. Ideal for personalized gifts and special occasions.

MachineM1 Ultra(Blue light · 20W)

Processing ModeProcess on baseplate

Processing typeEngrave

Thickness9mm

Settings

Version: 1.8.22

Precautions

Wear goggles that match the wavelength of the light source

When operating with open covers or using open-type devices, be sure to wear laser goggles that match the wavelength of the light source. Different light sources (blue light/infrared/CO2/UV) have different wavelengths; please pay attention to whether the wavelength protected by the goggles matches the laser;

Flammable materials should be placed near the smoke exhaust outlet

Flammable materials such as wood, paper, and fabrics should be placed near the exhaust outlet, so that sparks and smoke generated during processing can be promptly removed, reducing the risk of ignition.

Pay attention to odor prevention during processing

Materials such as leather, rubber, and silicone produce noticeable odors; ensure good ventilation and wear protective masks if necessary.

Handling when a flame alarm appears

If a flame alarm is triggered when processing flammable materials such as plywood, acrylic, or polyester mesh: stop processing immediately, maintain smoke exhaust operation, and only open the lid after confirming there is no open flame. Do not open the lid directly to promote ignition.

Prevent high-temperature burns after processing

Freshly processed materials and cuts are very hot; please wait for cooling or wear gloves to pick up parts; do not touch them directly.

🔔 Processing Tips

Clean the bamboo surface before engraving.

Wipe the surface after engraving to remove any residue and enhance contrast. For best results, use bold fonts and maintain sufficient spacing between letters when engraving small text.

Use proper focus for sharper text details.

Did these settings work?No results yet

No one has shared a result yet. Be the first to let other makers know if these settings worked.