Llaveros probeta laboratorio

To make this design you just have to follow the following steps: 

• We insert the drawing of a laboratory specimen, we will put the approximate size of about 6 cm since it will be a keychain and larger would be a little uncomfortable. Select it to engrave and the liquid mark to mark. 
• Generate the outline of the drawing in 2 and move it to the side. 
• Insert a 4 mm circle and place it centered on the top of the outline. When we have it in the desired position, we are going to select both shapes and we will click on combine and subtract in superposition. Select to cut. We place it in its initial position around the drawing. 
• We select everything and click on copy and then paste as many times as we need. 
• We insert text and we are going to write the names with the typography that we like the most. In this case I have used "hello Valentica". As this letter is attached, we must not forget to solder it before selecting it to engrave, otherwise it will be a little noticeable in the engraving. 
• We adapt the size of the text and place it in the place we like the most. 
• We can also make the engraving in another way, so that the liquid is filled and the name is unengraved. To do this, select the part of the liquid and the name and give it to combine and subtract in superposition. Then we select that part to record and see how the opposite effect to the one we had looks. Now I leave it to your choice. 
• We already have our design ready. 

We turn on our Xtool and place the material we are going to work with. In this case with 3 mm thick MDF. 

We check the parameters and hit start. 

We let our machine do all the work. 

Once we have our test tubes ready, all we have to do is pass the ring and turn them into original keychains. 

You can use any keychain you like but I have chosen to use colored keychains that give it a very fun touch. 

I hope you like them!