Report

[Laser cut and engrave] Engraved circular mirror with dragon and tiger yin yang design — Project made with xTool S1 machine for Laser cut and engrave.

Engraved circular mirror with dragon and tiger yin yang design

Instruction

pieddragonettigre

.xcs

Show 1 more

Application scenario

Laser processing (90min)

Machine & module

xTool S1

20W

Material used

1/8"(3mm) Basswood Plywood

multiplex3.6mm

Mirror Acrylic

1461

Information

      Engraved circular mirror with dragon and tiger yin yang design

Instruction

Step1

Preview

Hello, I present to you the dragon yin and yang tiger support made on 3.6 mm multiplex and black acrylic, for this you will need wood, an acrylic panel, contact style glue or glue, wood glue and black
paint

Step2

Preview

Be careful, the setting is for a 3.6 mm multiplex wood, if you use another material, you refer to the tested toast of this material for the adjustments

To make it easier for you, I put a 3mm base so that you use 3mm thickener material, use it instead of the 3.6mm one

Step3

Preview

Paint the wood black or another color this is up to you

Step4

Preview

Glue the acrylic sheet to the plate support with contact glue or from there super glue

the support to the foot so that it becomes one with wood
glue

Step5

Preview

That's it, enjoy your decoration.

If you don't want to put it with the support, it will also go very well on the wall, you just have to put a small sticky fastener like in the picture, I wish you a good day and good fun.

Comments