Report

[Laser cut and engrave] Double Xbox controller stand — Project made with xTool D1 Pro machine for Laser cut and engrave.

Double Xbox controller stand

Instruction

DoulbeXboxcontrollerstand4mm

.xcs

Application scenario

Laser processing (25min)

Machine & module

xTool D1 Pro

Material used

4mm cherry plywood

242

2432

Information

      If you need a way to store and. display your controllers or a little gift for a gamer friend then this might be your perfect next project.

This stand is designed to hold two Xbox One, Series S, or Series X controllers and is made from 4mm cherry plywood.

Instruction

Step1: Design and personalisation

Preview

This stand is designed to hold 2 Xbox controllers and can be personalised with custom engraving if required.

If you want to add engraving this can easily be added to the design before processing.

Step2: cutting

Preview

These are the settings used for cutting 4mm cherry plywood using the xTool D1 Pro 5w laser.

Step3: Assembling

Preview

This stand is very simple to assemble but will require some wood glue for extra strength where the stands meet the base plate.

Start by assembling the tow stands, which should simply slot together without any glue as shown in the pictures above.

Next, add a small amount of glue to the 4 tabs at the bottom of each stand. Then insert the tabs into the pre cut holes in the base plate. These may be some excess glue that will need to be cleaned before it dries.

Comments