Report

[Laser cut and engrave] Wall Mounted Mail Organizer with Paw Print Pattern — Project made with xTool P2S machine for Laser cut and engrave.

Wall Mounted Mail Organizer with Paw Print Pattern

Instruction

Mailbox 1

.xs

Application scenario

Laser processing

Machine & module

xTool P2S

55W

Compatible xTool Machine

10W, 20W

F2 Ultra UV

15W

80W

F2 Ultra

40W

F1 Ultra

20W

5W, 10W

5W, 10W, 20W

D1 Pro

5W, 10W, 20W, 40W

55W

10W

10W, 20W, 40W

M1 Ultra

10W, 20W

Material used

1/8"(3mm) Basswood Plywood

300

Information

      A mail organizer with a pet-lover friendly pattern on the front, made to hang unobtrusively on the wall, to keep your incoming mail from ending up on the kitchen table or cabinet right by the door, like ours always did. Now we can put it in this box and keep the pasta sauce off the snail mail. This one's cut out of 3mm basswood, but think of how nice it'd look if you cut it from acrylic.

Instruction

Step1: How to cut and assemble

You'll likely need a little more than 1 sheet of 12 x 20 x1/8 material.
I hang on to sheets that I couldn't use all of, so I can cut smaller pieces from different sheets.

Assemble with wood glue. Don't do what I did and inadvertantly put the side panels in the wrong orientation. They slant down toward the shorter front panel.

After assembly, glue the letters to the front. Paint them first if you like, I left mine au natural.

Comments