Laser Cut Wooden Christmas Ornament with Joy Wreath Design.

1.Open File

2. Position your chosen material on the lazerbed. 

3. Move the image in the CreativeSpace so you can align your lazer with the material so as to avoid material wastage. 

4. Set the correct processing parameters for your material, check it's set to output and cutting. 

5. Select the Red Layer (the cutting)
Set the Power 100
Set Speed8  
Set Number of passes 1

6. Select the Black Layer (the engrave )

Set the Power 80

Set Speed 200

Set Number of passes 1

1. Make sure to rub any edges to remove smoke marks and ash from the Lazer cutting process.

2.Varnish them. Any remaining smokey residue will be set into the varnish.Make sure you varnish the edges where there is the most smoke residue to seal them up. 

3.If your wood comes pre-varnished, still do this step of prep and varnish, except instead of varnishing the top and back of your cut parts, avoid the already varnished surface and varnish the lazercut edges along the side to stop that smokey residue marking hands.

You can use any material with a thickness of 3-6 mm.

4. Put all layers in right position.

5. You can color layers in favourite way.

So, it is ready!

6. Select the Black Layer (the engrave )

Set the Power 80

Set Speed 200

Set Number of passes 1