Açıklama
Make a finger-jointed wooden box that fits your stuff and your laser, in a minute.
Four box types
- Closed box, open tray, box with a lift-off lid, and a drawer with its own sleeve.
- Measure outside or inside: type the size of what goes in and the walls are added for you.
Joints that fit
- Finger joints sized to your material, from 1 to 12 mm thick.
- Kerf compensation, so tabs and slots come out at their true size.
- A lid and drawer gap you can tune, for a lid that drops on and a drawer that slides.
Dividers
- Up to 6 dividers each way, cross-lap slotted so they slot together with no glue.
Make it personal
- Engrave a name or a word on the lid or the front, in four fonts, with an optional border.
- Latin, Latin Extended, Cyrillic and Vietnamese letters.
Ready for your laser
- Every part is nested onto your sheet size, on as few sheets as possible.
- Red cut lines and blue engraving, 1:1 in mm, following the atomm colour spec.
- Download one SVG per sheet, or Open in Studio with everything in one file.
See it before you cut
- Live 3D preview with the lid lifted and the drawer pulled out.
- Ten presets to start from: keepsake, jewelry, tea, pencil and card boxes, a desk tray, a drawer, a gift cube, an organizer and a storage crate.
- Fabrication Tips walk you through the test cut, engraving, assembly and fit.
Works in 17 languages, in mm or inches.
How to use
- Pick a preset, or choose a box type.
- Set the size, outside or inside, and your material thickness.
- Add dividers and an engraving if you like.
- Check the 3D preview, then set your kerf and sheet size.
- Export: download the SVG sheets, or open them in Studio.
Yorumlar