HomeTemplatesTools & Special MaterialsGadgets
stephcreated
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Measuring Tape Label

Instruction
measuring_tape_label.xcs
measuring_tape_label
.xcs
Application scenario
Laser (15min)
Machine & module
xTool M1
10W
Compatibles · 10
Material used
3mm Basswood Plywood
20
437
Information
      So I used this as a label so my measuring tape always get returned to my craft room but you can easily customize this for Father's day!
Instruction
1
Step1: Finding your measurments
Preview
Preview
  • First pick your measuring your tape you would like to label
  • Next grab your digital calipers and take the measurement of the small circle on the measuring tape. 
    • For this 25 foot Stanley, my measure ment was 1.89" inches
2
Step2: Creating your Design
Preview
Preview
  • Create a circle from the left side panel using the dimensions 1.89" x 1.89" 
  • Add the Text you would like to engraved on your circle.
3
Step3: Laser!
Preview
Preview
  • Check all your settings
    • The circle should be set to “cut”
    • And your text set to “engrave”
4
Step4: Assembly
Preview
  • Grab some glue and put some on the stanley where the circle is going to go.
    • Place your project on there and let it cure!
5
Step5: Finished Project
Preview
Preview
Preview

There you have it!

Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC0