Herb THE berT
Report

Mini garland

Instruction
kleine fähnchen.xcs
kleine fähnchen
.xcs
Application scenario
Laser processing (20min)
Machine & module
xTool M1
10W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
24
442

Information

      Another spontaneous project request from my wife
"Can you do something with the laser for tomorrow?" :D
aaaaaalright :)
This is also a good way to use wood scraps
I also use 2 small wooden sticks and a string
    

Instruction

1

Step1: Rectangle and center

Mini garland instruction: step 1 - Rectangle and center
Preview
Mini garland instruction: step 1 - Rectangle and center
Preview
Mini garland instruction: step 1 - Rectangle and center
Preview
2 More images

Create a rectangle

in my case it is 2cm wide and 3cm high

on the right in the text settings you can slightly round the corners

 

Paste the text. I write the whole text right away to see how it looks as a whole, and then I separate the individual letters

 

When placing the letters on the rectangle, I always tend to place them as centered as possible, but that's not necessary because we'll center them.

2

Step2: Glue......No we have a laser cutter :)

Mini garland instruction: step 2 - Glue......No we have a laser cutter :)
Preview
Mini garland instruction: step 2 - Glue......No we have a laser cutter :)
Preview
Mini garland instruction: step 2 - Glue......No we have a laser cutter :)
Preview

Now you could fire up the laser cutter and glue the flags on

but we have a laser cutter, so we make holes and make the project glue-free :)

 

For the holes you have to pay attention to how thick the string is that you use

 

lastly, I added a point to the flags at the bottom with edit node

 

I left the text and holes editable in the XCS file

3

Step3: assembling

Mini garland instruction: step 3 - assembling
Preview
Mini garland instruction: step 3 - assembling
Preview
Mini garland instruction: step 3 - assembling
Preview
Mini garland instruction: step 3 - assembling
Preview

a little tip here
glue the end of the cord together with a piece of tape so that it does not fray and is difficult to get through the hole

Comments

Remixes

xTool Supplies Used in This Template

xTool M1
xTool M1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood