![[Laser cut and engrave] Bunny Air freshener](https://image-res.xtool.com/ali-res/community/making/4e202ff8-b335-4649-836f-ef804ee7d840.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Bunny Air freshener
Instruction
Information
It is the holidays so Easter is in the air, may as well be as a fragrant as well.
Instruction
Step1
Step 1) This little guy starts out as a oval brought in with the insert button, this first oval is sized to the approx. size needed. A second smaller oval is made the same way and copied and pasted 3 times to make 4 the same.
Step2
Step 2) this step I took one of the small ovals and resized it a bit bigger positioned it on a slight angle just on the top left corner of the large oval making sure it was over lapped, this oval was copied and pasted to make a second one but the reflect button was used to change the angle the opposite as the first one. It too was moved to the other side just like the first one.
Step3
Step 3) Once again this same procedure was done but this time near the bottom corner of the large oval, these will eventually be the feet or legs. Same steps with the angles and placement. However this time they were grouped and then copied and pasted to make a second pair. Now that the top and bottom were both in place it was all united to make the outline of the bunny with ears and feet.
Step4
Step 4) In this step the second set of feet were placed in the same place as the first set but this time instead of uniting them they were adjusted to be scored only same as the 2 inside pieces for the ears and eyes. the mount however was made by using a larger oval over top and using the combine feature it was subtracted to create a smile.
Step5
Step 5) this was time to send it all to the laser the outline setting were adjusted along with the score settings. Once the bunny came to life it was then glued to the old plug in air freshener, the small hole is for the night light the air freshener provides. hope you enjoy...