Fan Switch

I created the icons in XCS using simple graphics. Next, I made the component that connects to the fan. I used a small square and two holes for this purpose. Please keep in mind that although I used acrylic, you can use any material of your choice.

For this project, I used acrylic. However, you can use any material that you prefer. Since it was my first time working with acrylic, some of the engravings were not very clear. Therefore, I suggest that you do a test square before starting your project.

Please remember that this is black acrylic and an S1 40-watt laser, so make sure to adjust your parameters for both your machine and the material. Also, always wear laser-safe glasses when laser engraving.

Now that you're done, you will never forget which cord is for your fan and which is for your light. Good job!