![[Laser cut and engrave] Business card Jig no assembly](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/4978f78c-ced0-48e7-b5c0-68137efd5304?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Business card Jig no assembly
Instruction
Information
This is a business card JIG that is made using a single piece of wood without any glue. However, the only drawback is that it takes around an hour and a half to make it, using an S1 40-watt machine.
32/312
Instruction
Step1: Design
This design uses only one piece of wood, but please be careful as it requires a long engraving time. Therefore, plan accordingly. Although I have made other Jigs using two pieces of wood, I found that the business cards would often get wedged between them. This design, on the other hand, uses engraving to create a small hole where the card can sit securely.
Step2: Material
You should only use wood that you understand well.
Step3: Laser time
IMPORTANT:
When using a laser, it is important to ensure that you are using the appropriate settings and taking necessary precautions. Watch this cut the whole way, though, as it is a high-power engrave. Always err on the side of caution and prioritize safety. Remember to wear laser-safe glasses throughout the operation. Be vigilant and exercise caution at all times.
Step4: You're Done
You are done with your jig, good job
