For this project, I used a premade Xtool frame and created an outline that I would cut while keeping the interior as a score to add detail. Then, I added my text and picked a font that would fit them. For the cursive font, I made sure to weld the text. After that, I added a rounded rectangle and used the edit node to make it long. Finally, I added two circles to create hooks.

For this project, you only need plywood because it is quite simple. However, if you prefer, you can use a different material such as Acrylic. But, for me, plywood works well. You could also opt for a different type of plywood or even stain it after completion.

Please remember that these settings are specifically for an xtool S1 40watt laser machine, but you can adjust them to better suit your laser and material. Make sure to always wear laser-safe glasses and set the text to engrave. Set both the outer and inner rings to cut. Lastly, it's important to always wear laser-safe glasses for your safety.

You're done! Good job.