HomeTemplatesDecorHome DecorShelves & Holders
mandygammond
Report
[Laser cut and engrave] Good luck pocket hug
Project made with xTool P2 machine for Laser cut and engrave.
[Laser cut and engrave] Good luck pocket hug
[Laser cut and engrave] Good luck pocket hug

Good luck pocket hug

Instruction
good luck PH.xcs
good luck PH
.xcs
Application scenario
Laser (5min)
Machine & module
xTool P2
Compatibles · 8
Material used
Cherrywood Plywood
41
315

Information

      Note that tis is for the wooden pocket hug only and not the backing card template (although there is an example of it on here)

Instruction

1

Step1: Placement

Good luck pocket hug instruction: step 1 - Placement
Preview

Plae the project over the material you want it cut on. Ensure the settings are correct for the thickness of material you are using.  

Red cut

Blue score

Green engrave

 

Press go

2

Step2

Good luck pocket hug instruction: step 2 -
Preview
Good luck pocket hug instruction: step 2 -
Preview

Once cut clean with a wipe if needed and attach to your own handmade backing card. Here is an example of the one I use. It is 8cm wide by 10cm tall. The pocket hug is attached using a glue dot. 

Comments

Remixes

xTool Supplies Used in This Template

xTool P2
xTool P2

License

CC BY-SA