I created the file in Adobe Illustrator.

1. Create a text box.
2. Copy and Paste or type out the verse.
3. Choose a font.
4. Create a rectangle the size of the engraveable part of the sign.
5. Place the text box in the rectangle and resize until it fits in the rectangle.
6. Create another text box and type the name.
7. Choose a font. 
8. Resize the text box and place over the verse/rectangle to determine correct size. 
9. Move the name text box below the rectangle.
10. Choose the two text boxes. Select Create outlines. And Unite outlines so the words are all one piece.
11. Choose different colors for the fill/stroke for different steps. I made the rectangle orange stroke, the verse blue fill and the name red stroke.
12. Save as an SVG.

Upload the SVG into XCS. You can resize the file as needed for different size boards.

1. Click the folder icon.
2. Select Import Image.
3. Select the saved SVG file.
4. Resize as needed.

You can readjust the file if you have a different size sign and want the word mom above or below the verse. You can also add a different word such as Grandma, a name, etc.

I engraved on a sign bought from Hobby Lobby using the slide extension. This sign was the perfect fit for the slide extension.

1. Follow the Xtool instructions to set up the slide extension with the F1 and calibrate.
2. Place sign or material on the slide extension and line up with left edge.
3. Select the rectangle outline and text box and start framing.
4. Line the rectangle up with the edges of the sign.
5. Select Ignore for the rectangle.
6. Select the text box and frame. Make sure it is on the sign where you want it to be.
7. Select the settings to engrave the sign.
8. Select Process.
9. Press start and hit the start button.

I used the slide extension again and the red oak wood from Xtool. This wood did smoke a lot and the cover could not be completely closed. I had to stop the cut periodically to let the smoke air out. If you have the option to cut with an enclosed machine, I would do that. You can also use another font and have the letters cut separately so you do not have to use the slide extension if you are concerned about the smoke or in an area that is not well ventilated. The F1 is great for engraving the sign though. I used the 3mm Basswood settings to cut and they worked great.

1. Arrange your wood on the slide extension.
2. Use the clamps to clamp the wood flat.
3. In XCS, reposition the word so it is in the workspace.
4. Select Framing and reposition where you want it to cut on your board. Avoid your clamps.
5. Select the 3mm Basswood settings or the required settings for your chosen wood.
6. Select Process.
7. Start the cut.
8. Monitor for excess smoke or flames. Pause the cut if needed.
9. When complete, Gently press the letters out from the board.

I use loctite gel superglue to attach the word to the sign. I sometimes put double sided adhesive on the back of the board before cutting and use that to attach.

1. Use chosen glue or adhesive to place the word in the center of your sign.
2. Put hanging hooks on the back if desired.
3. Display or give as a gift!