Ensure that if your tray is too deep for the slats in the P2 then remove them. I also had to take my tray in the bottom out for it to fit. When setting up your material remember to change the set to ‘open’ so that it recognises that the tray is not in there. 

I also took a photo of the measurement of the thickness of material as, for me, it is the best way to do this.

I also took a photo of the measurement of the thickness of material as, for me, it is the best way to do this.

To do this select the little + icon nect to the distance book. It will ask you to click where to measure. Follow the instructions and it will measure automatically for you. 

Place the design over the part you need engraving.  Continue to process project. Ensure you are checking the machine at all times.

Once the project has finished engraving, take out the tray and wipe off to clean. Your tray is ready to load up with flowers, drinks and food!