HomeTemplatesOffice & StationeryDesk Organization
tpleo54
Report
[Laser cut and engrave] Picnic Table
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Picnic Table
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Picnic Table
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Picnic Table
[Laser cut and engrave] Picnic Table
[Laser cut and engrave] Picnic Table
[Laser cut and engrave] Picnic Table
[Laser cut and engrave] Picnic Table
[Laser cut and engrave] Picnic Table

Picnic Table

Instruction
picnic table.xcs
picnic table
.xcs
Application scenario
Laser
Machine & module
xTool S1
40W
Compatibles · 8
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
328
1836

Instruction

1

Step1: Put an angle on the legs

Picnic Table instruction: step 1 - Put an angle on the legs
Preview
Picnic Table instruction: step 1 - Put an angle on the legs
Preview
Picnic Table instruction: step 1 - Put an angle on the legs
Preview

Draw a rectangle for the leg then angle it 30 degrees. Then place a small rectangle on the end and hit subtract. Copy, paste and reflect.

2

Step2: Combine the parts

Picnic Table instruction: step 2 - Combine the parts
Preview
Picnic Table instruction: step 2 - Combine the parts
Preview
Picnic Table instruction: step 2 - Combine the parts
Preview

Line up all of the parts and combine them all together.

3

Step3: Make notches for the support.

Picnic Table instruction: step 3 - Make notches for the support.
Preview
Picnic Table instruction: step 3 - Make notches for the support.
Preview
Picnic Table instruction: step 3 - Make notches for the support.
Preview

Make a rectangle for the support then add small rectangles to the ends and hit combine.

4

Step4: Cut it all out

Picnic Table instruction: step 4 - Cut it all out
Preview

Cut all the parts out

5

Step5: Start assembly.

Picnic Table instruction: step 5 - Start assembly.
Preview
Picnic Table instruction: step 5 - Start assembly.
Preview

Start with the brace and the two sides and glue together. Then just glue each board onto the ends.

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC-SA