HomeTemplatesOthers
PILED
Report
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Rust Removal

Instruction
rust.xcs
rust
.xcs
Application scenario
Laser (10min)
Machine & module
xTool F1
2W
Compatibles · 5
Material used
Stainless Steel
93
1401
Information
      I used the 2W IR laser to remove rust from an old chisel
Instruction
1
Step1: Clean
Preview

First, remove any excess rust. I used a scourer under the sink.

Then, completely dry with a paper towel.

Before above, after below. 

2
Step2: Preparation
Preview

Measure the length and width of the tool then change the square size in xTool creative space file.

Check the size is correct by framing. 

 

 

3
Step3: Engrave
Preview

90% of the surface-level rust has been removed from just one pass. More scouring of the most rusted spots would have ensured a more even finish. 

Before above, after below. 

Comments
Remixes
xTool Supplies Used in This Template
xTool F1
xTool F1

License

CC BY-NC-SA